1. For the molds to retain their shapes store them in a single layer, do not pile them up.

2. After using clean the mold with tepid water and soap, don’t use abrasive products. Don't forget to clean the mold between the castings, especially when using pigments or different colour cement. Gently remove the dry particles of concrete with soft sponge and soap to avoid scratching the silicone surface.

3. Keep your molds away from direct sunlight as UV may cause damage to silicone.

4. Don’t pull at the mold too strongly. Release the cast product by gently moving around and unsticking the mold rather than pulling strongly at one end. It is strongly recommended to use release agent with all pot molds to reduce the pulling force.

Free shipping is offered on orders of 250+ Euro.

Please note that refunds are issued only after formal postal investigation which can take up to 30 work days, i.e. post claims, technical examination, etc.

Molds are made of durable, stretchy silicone. The casting result and mold life depend on cement mix you use. All molds are tested and proven to work with concrete without breakage. If your product breaks, try different mix.

Planter/cup molds work best with release agent. It is possible to turn most molds inside out to ease the demolding.

If you experience difficulties with demolding, please see the listing photos (some have pictures of demolding), check out Trendbolt channel on Youtube for videos and read booklet you get with your product.

For products with thin walls recommended curing time is 24+ hours. If it breaks, change your mix.

Don't forget to clean your mold thoroughly when using pigments/cement in different colours.

CONCRETE:
Concrete is durable, but it can break if dropped or knocked against hard surface.

Do not use it to serve/store food or liquids.

Do not put it in the dishwasher or microwave oven.

Clean with a slightly damp cloth.